D-Link DES-3624 Series User Manual page 58

The fields you can set are:
Anchor There are either two or three listings representing the anchor port for each of the three trunk
groups available on the Switch (the third listing will only be displayed if an optional two-port plug-in
module is being used). The anchor port must fall within the port range and be included as a member port.
Name Enter the desired group name. In the example pictured above the first trunk group designates a
trunk connection between a Switch on the 6
Members Select between 2 to 8 ports in the first two entries for this field. The number of ports defined
here start from the anchor port. Thus, in the example pictured above containing 4 ports in the first trunk,
the ports in the trunk group will include ports (anchor), 5, 6, 8, and 11. The third entry (used for 2-port
front-panel modules) has a permanent setting of 2 ports.
State Enabled, Disabled or Clear. Be careful when clearing trunk groups as the connections will return to
normal operation and may cause signal loops.
Port Range is a read-only field which lists the possible ports in a selected trunk.
Press APPLY to let the changes take effect.
58
Figure 6-15. Port Trunk screen
floor and this one on the 7
th
Stackable NWay Ethernet Switch User's Guide
floor
th
Using the Console Interface