Aim Duration - Motorola LS3408-FZ20005 Product Reference Manual

4 - 8 Symbol LS3408 Product Reference Guide

Aim Duration

When the scanner is in Level trigger mode (default mode), Aim Duration sets the amount of time the aiming dot
displays before turning into a scanning beam. This parameter has no affect when the scanner is in either of the
Two Stage trigger modes. See Trigger Mode on page 4-7 for a description of each of the trigger modes.
The aim duration is programmable in 0.1 second increments, from 0.0 to 9.9 seconds. The default Aim Duration is
0.0 seconds. When set to 0.0 seconds, no aiming pattern appears before a decode session.
To set an aim duration, scan the bar code below. Then scan two numeric bar codes in Appendix D, Numeric Bar
Codes that correspond to the desired aim duration. Enter a leading zero for durations less than 1.0 seconds. For
example, to set an aim duration of 0.5 seconds, scan the bar code below, followed by the 0 and 5 bar codes. In
case of an error, or to change the selection, scan the Cancel bar code on page D-3.
Aim Duration