D-Link DVG-1402S User Manual page 36

These external services may be modified by clicking its corresponding edit icon, or they
may be deleted by clicking the corresponding delete icon. Though there are seven fields
available to configure the Virtual Server, in most cases, only the IP address of the
Virtual Server will be needed for implementation. To enable an already existing Virtual
Server, click its corresponding edit button, configure the appropriate fields listed below
and set the Status fields to Enabled by clicking the radio button. To configure other
virtual servers for the Router, configure the following fields and click Apply.
Index
Private IP
Protocol Type
Start/End Global Port
Start/End Local Port
This is an index number used to identify the Virtual Server
entry.
Enter the IP address of the Virtual Server.
The protocol type used for the Virtual Server. The user may
select TCP, UDP or Both, depending on the type of Virtual
Server implemented.
Enter a range of ports on the device on the WAN side of the
network that will be accessing the Virtual Server currently being
configured. Commonly, this range of ports is identical to the
local range of ports. Existing Virtual Servers may already have
their well-known port ranges listed but this may need to be
changed in certain circumstances.
Enter the range of ports of the Virtual Server's computer.
Existing Virtual Servers may already have their well-known port
ranges listed but this may need to be changed in certain
circumstances.
35