SpaNet Mini 1 Quick Start Manual

WARNINGS
Risk of electrical shock
ALL ELECTRICAL CONNECTIONS MUST BE PERFORMED BY A LICENSED ELECTRICIAN AND
•
MUST CONFORM TO ALL NATIONAL, STATE AND LOCAL ELECTRICAL CODES IN EFFECT AT
THE TIME OF INSTALLATION INCLUDING ENSURING PARTS ARE INSTALLED IN THE
CORRECT ZONE AND EQUIPOTENTIAL BONDING IS CARRIED OUT IF REQUIRED.
The appliance should be supplied through a residual current device (RCD) having a rated
•
residual operating current not exceeding 30mA.
The appliance must be connected to a suitable rated and weather protected power supply. The
•
supply line should be a dedicated power circuit and means for disconnection must be incorporated in
the fixed wiring in accordance with your local wiring regulations. Means for disconnection from the
supply mains should have a contact separation in all poles that provide full disconnection under over
voltage Category III conditions.
• Earthed appliances must be permanently connected to fixed wiring.
The appliance contains no serviceable parts. Do not attempt service of this control pack. Contact
•
your dealer or authorised service agent for assistance.
Turn the mains power OFF before servicing appliance or modifying any cable connection.
•
Suitable for indoor use only or when installed under a weatherproof spa skirt. The appliance should
•
be installed in an enclosure such that all electrical connections cannot be accessible to the user
without the use of a tool.
Low voltage or improper wiring may cause damage to this appliance. Read and follow all wiring
•
instructions when connecting to power supply.
If the supply cord is damaged it must be replaced by the manufacturer, its service agent, licensed
•
electrician or similarly qualified persons in order to avoid a hazard.
To prevent electric shock hazard and/or water damage to this appliance, all unused receptacles
•
must have a water proof seal in place.
Parts incorporating electrical components must be located or fixed so that they cannot fall into the
•
bath or spa.
Parts containing live parts, except parts supplied with safety extra-low voltage not exceeding 12V
•
must be inaccessible to a person in the bath or spa.
This appliance must NOT be installed in proximity to highly flammable materials.
•
Water temperature in excess of 38
•
It is the spa manufacturer's and/or installer's responsibility to select suitable loads and configure
•
load shed settings (if required) to ensure the system does not exceed its rated maximum total load.
It is the installer's responsibility to ensure the floor can support the expected load of the bath or spa
•
and an adequate drainage system has to be provided to deal with overflow water.
A whirlpool spa should incorporate a water filtration system where the required level of water purity
•
can be achieved.
An adequate drainage system must be provided if the equipment is to be installed in a pit.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory
•
or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
•
V.2005
C may cause hyperthermia (heat stress).
o
Page | 1