Sleep Operation - Haier HSU-12HEA03/R2 - annexe 1 Operation Manual

Operation

Sleep Operation

Before going to bed, you can simply press the
SLEEP button and unit will operate in SLEEP
mode and bring you a sound sleep.
Use of SLEEP function
After the unit starts, set the operation status,
then press SLEEP button before which the
clock must be adjusted and time being set.
Operation Mode
1. In COOL,DRY mode
1 hours after SLEEP mode starts, temp. will
become 1 C higher than temp. setting. After
O
another 1 hours, temp. rises by 1
The unit will run for further 6 hours then stops
Temp. is higher than temp. setting so that room
temperature won't be too Iow for your sleep.
SLEEP operation starts
1 hr
Rises 1
1 hr
Temp.setting
In COOL, DRY mode
In HEAT mode
2.
1 hours after SLEEP mode starts, temp
will become 2 O C lower than temp.
setting. After another 1 hours, temp
decrease by 2 C further. After more
O
another 3 hours, temp. rises by 1
further. The unit will run for further 3
hours then stops. Temp. is lower than
temp. setting so that room temperature
won't be too high for your sleep.
Temp.setting
1 hr
Decreases 2
1 hr
Decreases 2
3 hrs
SLEEP
operation starts
In HEAT mode
4
C further.
O
SLEEP operation stops
Approx.6hrs
O
Rises 1 C
O
C
Unit stop
C
O
Unit stop
O C
C
O
3 hrs
Rises 1 O C
SLEEP
operation stops
In AUTO mode
3.
The unit operates in corresponding sleep
mode adapted to the automatically selected
operation mode.
4. In FAN mode
It has no SLEEP function.
5. Set the wind speed change when sleeping
If the wind speed is high or middle before
setting for the sleep, set for lowing the wind
speed after sleeping.
If it is low wind, no change.
Note
When TIMER function is set, the sleeping function
can't be set up .After the sleeping function is set up,
if user resets TIMER function, the sleeping function
will be cancelled; the machine will be in the state of
timing-on.
POWER/SOFT Operation
(1)
POWER Operation
When you need rapid heating or cooling, you can use this
In COOL mode, fan speed automatically takes
function.
high speed of AUTO fan mode. In HEAT mode, fan speed
automatically takes medial speed of AUTO fan mode.
(2)
SOFT Operation
You can use this function when silence is needed for
rest or reading. In SOFT operation mode, fan speed
automatically takes low speed of AUTO fan mode.
Note
During POWER operation, in rapid HEAT or COOL
mode the room will show inhomogeneous temperature
distribution. Long period SOFT operation will cause
effect of not too cool or not too warm.
To cancel POWER or SOFT operation
Press POWER/SOFT button again ,POWER or SOFT
disappears.
HEALTH Operation
Healthy Negative ions
The anion generator
anion effectively balance the
generate a lot of
quantity of position and anion in
also to kill bacteria and speed up the dust sediment
in the room and finally clean the air in the room.
in the airconditioner can
the air and