Heat Operation - Haier HSU-09HEA03/R2 - annexe 2 Operating Manual

Operation

Heat Operation

(1) Unit start
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
(2) Select operation mode
Press MODE button. For each press, operation
mode changes as follows:
AUTO COOL DRY
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
Every time the button is pressed, temp. setting decreases 1
Unit will start running to reach the temp. setting on LCD.
(4) Fan speed selection
Press FAN button. For each press, fan speed changes
as follows:
Remote controller:
AUTO
IN HEAT mode, warm air will blow out after a short period of the time due to cold-draft
prevention function.When FAN is set to AUTO, the air conditioner automatically adjusts
the fan speed according to room temperature.
(5)
Unit stop
Press ON/OFF button, the unit stops.
Hints
Remote controller can memorize each operation status. When starting it next time,
just press ON/OFF button and unit will run in previous status.
No reelecting is needed (TIMER ON/OFF SLEEP SWING needs reelcting)
HEAT
FAN
LO MED
12
ON/OFF
1
5
MODE
2
FAN
o
C 4
o
SWING
C
HEALTH
SLEEP
LOCK
HI
TEMP
3
3
SET
TIMER
CLOCK
RESET