Auto Operation - Haier HSU-09HEA03/R2 - annexe 2 Operating Manual

Operation

Auto Operation

(1) Unit start
Press ON/OFF on the remote controller, unit starts.
(2) Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
AUTO
Then
Select Auto operation
(3) Fan speed selection
Press FAN button. For each press, fan speed changes
as follows:
Remote controller:
Air conditioner is running under displayed fan speed.
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
(4)Unit stop
Press ON/OFF button, the unit stops.
Hints
Remote controller can memorize settings in each operation mode. To run it next time just
select the operation mode and it will start with the previous setting.
No reelecting is needed.(TIMER ON/OFF
Cautions:
On cooling only unit, heating mode is not available,
After replacing batteries, press ON/OFF, and display
becomes as follows:
Operation mode: AUTO, Temp. :No
HEAT
COOL DRY
AUTO LO MED HI
SLEEP SWING needs reelecting)
9
FAN
ON/OFF
MODE
2
FAN
SWING
SLEEP
LOCK
Note:
The above information is the
explanation of the displayed
information therefore varies
with those displayed in actual
operation.
TEMP
SET
TIMER
3
CLOCK
HEALTH
RESET