Operation; Cool Operation; Auto Operation; Heat Operation - Haier HSU-30HEA13 - annexe 1 Operation Manual

Operation

Unit start / stop
Press ON/OFF button, unit starts or stops.
Select temp.setting
Remote
Operation
Display Board
Controller
Mode
AUTO
COOL
DRY
HEAT
FAN nothing

Auto Operation

According to the automatic
choice system in temperature
in indoors cold or make the
hot movement.

Heat Operation

Note:
In HEAT mode,warm air will blow out after a short periodof the time
due to cold-draft prevention function.
When FAN is set to AUTO, the air conditioner automatically adjusts
the fan speed according to room temperature.
Cooling only unit do not have displays and functions related with heating

Fan Operation

1.
When FAN is set to AUTO,
the air conditioner
automatically adjusts
the fan speed according
AUTO
to room temperature.
2.In FAN operation mode
the unit will not operate
in COOL mode but only
in FAN mode ,AUTO is not available in FAN mode.And temp.setting is disabled.
Note
Under the mode of auto operation, air conditioner will
automatically select Cool or Heat operation according
to room temperature. When FAN is set to AUTO, the
air conditioner automatically adjusts the fan speed
according to room temperature.
In DRY mode, when room temperature becomes
lower than temp.setting+2 o C,unit will run intermittently
at LOW speed regardless of FAN setting.
In FAN operation mode, the unit will not operate in
COOL or HEAT mode but only in FAN mode ,AUTO is
not available in FAN mode.And temp.setting is disabled.
In FAN mode,SLEEP operation is not available.
LO MED HI

Cool Operation

Dry Operation
Note:
In DRY mode,when room temperature becomes lower than temp.setting
+2 C, unit will run intermittently at LOW speed regardless of FAN setting. 0
Air Flow Direction Adjustm
Vertical flap
Pos.1
Pos.2
Pos.3
Pos.4
Pos.5
FRESH
Pos.6
swing)
(Auto
Health airflow Operation
3.The cancel of the health airflow function
Press the button of health airflow again, both the inlet and outlet grills of the
air conditioner are opened, and the unit goes on working under the condition
before the setting of health airflow function.
After stopping, the outlet grille will close automatically.
Notice: Cannot pull direct the outlet grille by hand. Otherwise,the grille will run
incorrectly. If the grille is not run correctly,stop for a minute and then start,
adjusting by remote controller.
Note:
1 .After setting the health airflow function, the position of inlet and outlet grills is fixed.
2.In heating, it is better to select the
3.In cooling, it is better to select the
4.In cooling and dry, using the air conditioner for a long time under the high air humidity,
a phenomenon falling drips of water occurs at the outlet grille .
5.Select the appropriate fan direction according to the actual conditions.
Remote controller can memorize each operation status. When starting it
next time,just press ON/OFF button and unit will run in previous status.
Horizontal louvers
(This function is unavailable
on some models.)
Pos.1
Pos.2
Pos.3
Pos.4
FRESH
Pos.5
The setting of health airflow function
1).Press the button of health airflow,
on the display. Avoid the strong airflow blows
direct to the body.
2).Press the button of health airflow again,
appears on the display. Avoid the strong
strong airflow blows direct to the body.
mode.
mode.
Pos.6
Pos.7
Pos.8
appears
2