Puesta En Marcha; Servicio - Beko QWIK-PURE CS 100 Instructions For Installation And Operation Manual

Putting into operation • Puesta en marcha
Mise en service • Colocação em funcionamento
Utilisation • Operação
16
Operation • Servicio
water
agua
eau
água
S
S
deutsch
Fill QWIK-PURE CS with clean water
®
• Take off the cap, remove filter mat from
the pressure relief chamber
• Let in the water through the inlet open-
ing: container and filter chamber are
filling up.
• Shut off the water when it starts to come
out at the water outlet.
The water level will sink due to the
gradual water intake of the filter.
• Fill up with clean water as required.
• Install again filter mat and presuure
relief chamber
The QWIK-PURE CS is ready for op-
®
eration:
• Compressor condensate can now flow
into the QWIK-PURE CS via the pres-
®
sure relief chamber.
Note:
Open the outlet of the condensate
drain!
Check all connections for leaks!
english
To ensure trouble-free operation, ob-
serve all the points listed under Main-
tenance:
The constituents of the compressor
condensate will depend on the specific
application.
It is part of the operator's duty of care to
take the necessary precautions, where
appropriate.
QWIK-PURE CS 100, 200
®