GE Monogram ZBD5900F01SS Use And Care Manual page 23

Before You Call For Service
Dishwasher
@estions ?
Use this
problem
SO[7)eT
PROBLEM POSSIBLE CAUSE
Dishwasher won't start
All Cycle Status
Indicators flashing
or beeping every 30
seconds (on models
ZBD5700 and ZBD5900)
Flashing SUPER WASH
light (on models
ZBD5700 and ZBD5900)
Motor starts but water
doesn't enter dishwasher
(Flashing FAST WASH)
(on models ZBD5700
and ZBD5900)
Program taking too
long or not advancing
properly (Flashing
NORMAL WASH light)
(on models ZBD5700
and ZBD5900)
Water does not empty
out of dishwasher
(Flashing RINSE llght)
(on models ZBD5700
and ZBD5900)
Dishwasher continues to
drain (Flashing temp
light) (on models
ZBD5700 and ZBD5900)
Yellow color on dishes
and glassware
Door not properly closed
Power supply not
connected.
Child I,ockout mode is
selected
Door opened during
cycle when water is hot
Timer not set to start of
wash cycle
Dishwasher is paused
Door not properly closed
Inlet water temperature
is greater than 175°F.
Water supply valve
turned off
Low inlet water
temperature
Outlet blocked
Incorrect fill level or
fill time
Water has iron or other
mineral content
WHAT TO DO
•Press door until it clicks shut.
•Check dishwasher is plugged in and
sx_Jtch is on.
•Press and hold desired button for two
seconds. See Child Lockout mode section
fin: models ZBD5700 and ZBD5900.
•Relatch door. Wait a ti_w minutes,
dishwasher will restart automatically.
•Turn to Cycle Selection starting position
and Option dial to desired position.
•To restart the wash, press the selected
wash button.
•Press door until it clicks shut.
•Reduce hot water inlet temperature to
below 150°F.
•Check water supply _dve.
•Allow time to heat water (up to one hour).
•Check inlet water temperature.
•Conne( t to hot water supply.
•Check outlet hose for kinks and sharp
bends.
"Check and (lean the drain pump filter.
•Clmck sink trap, garbage disposal and air
gap for blockage.
•Check fill level. See Water Fill I_evel
section.
"(;all for service.
•A special filter in the water supply line
is the only way to correct this problem.
Conta(t a water soiiener company.
22