Nsf International - GE Monogram ZBD5900F01SS Use And Care Manual

Control Panel - ZBD5700 & ZBD5900
Dishwasher
4. WATER TEMP--This option proxides exua heat to increase water temperature ti)r best perli)nnance.
It is used best _fith heavilpsoiled (fishes. This option cannot be used _fith RINSE & HOI D.
NORMAL--This is file detmflt seuing_wash and rinse water temperatures up to 149 oF.
BOOST--This water temp selection pr_Mdes a wash and rinse with water temperatures up to 158°F.
SANI--This water temp selection pr_Mdes a sanitizing wash and rinse with water temperatures up to 171 °F.
NSF INTERNATIONAL
Meets NSF Protocol for Performance of Domestic Spray-
Type Dishwashers [No. 96/011/480/2480] Requirements
for cleaning and sanitization of dishes, glasses and utensils.
5. DELAY START--This option will alh)w y{tu/o delay the start time of any wash _ycle except RINSE & HOI _D
ti)r up to 6 hours.
1. Select the delay stmt y{tu want by pressing the DEI AY START button. Multiple pressing will aherna/e the
delay time belween 2, 4 or 6 hours and OFF.
2. Select the wash _ycle you want. The DEIAY START light/liglns will flash to indicate time selected.
3. The flashing Cycle Stares Indicators show h{tw many hours will elapse betore washing begins.
6. CLEAR--If you wish to change the wash cycle after it has started or wish to turn the dishwasher offbetore the
wash finishes, it's simple. First pause the dishwasher by pressing the selected Cycle Selection
button, then press the CLEAR button. The dishwasher will then drain. You can now select a new
wash cycle if you want. If you don't, the dishwasher will drain and all Cycle Status Indicators will go
out. If you have selected a new wash cycle, remember to add more detergent to the detergent
compartment if required.
Start a
wash load
To start the dishwasher, close the (loot until it locks in place, push the desired Cycle Selection button, and
then select the desired Option buttons. There is a time delay belween star/-up and water fill so you will not
hear any wash action right away.
The (loot nmst be closed and latched into place to select a CYCI_E Selection or an option.
If the door is opened during a _ycle and left open, the dishwasher will beep once every nfinute until the (loot
is closed and latched into place.
To interrupt/pause a cycle, press the selected cycle button. The Stares Indicators will flash.
CAUTION: Be careful when opening the door; the hot steam that escapes when the door is opened may
cause injuries. Stand back as you open the (loot and allow the steam to escape.
_ATTENTION : Faites attention lorsque vous otmez la porte. La vapeur br01ante qui s'_?chappe lorsque
vous ouvrez la porte pendant un programme de lax'age peut causer des brfilures. Lorsque
vous ouvrez la porte, reculez et laissez la vapeur s'dchapper de l'appareil.
To restart the wash process, close the (loot until it locks in place. Re-press the cycle button. There may be a
time delay of up to a ti_w nfinutes becm_se the water temperature needs to stabilize beti)re it starts the wash
cycle. During this time the DRY light will be on.
Tone
Silencing
You can prevent the beep flom sounding when selecting control settings.
1. Press the CLEAR and FAST WASH buttons together prior to selecting settings.
2. To have sound again, simply press the CLL4R and FAST _,,\2_SHbuttons together again.
10