GE Monogram ZBD5900F01SS Use And Care Manual page 18

The Wash
Filters
In addition to the glass trap, your dishwasher
has three fine filters-
• a two piece round perfi)rated stainless steel
filter located in tile base of the dishwasher.
• a finer mit ro-mesll filter lo(ated under tile
stainless steel filter.
• a super fine fiher lo(ated below the lower
spray arm.
Remove the stainless steel filter by first twisting
and removing tile glass trap. Lift out tile
stainless steel filter.
Attached to the underside of this filter is the
micro-mesh filter. To remove the mlcro-mesh
filter, squeeze the two (lips above the stainless
steel fiber to release the mi(ro-mesh.
To remove the super fine filter, remove the
lower spray arm. Grasp tile super fine filter
around the outer edges. Remove by pulling
upwards, it will unclip. Unscrew tile tower
counterclockwise. Tile right half of tile stainless
steel filter can now be removed.
To clean filters, place m_der running water
and gently brush with a soft bristled brush.
Be careflfl not to deflnm filters while cleaning,
as this may prevent them from being properly
re-installed.
The super fine filter is self-cleanlng, there is
no need to clean it. This filter need only be
removed if you want to remove the right half
of the stainless steel filter.
Replace your filters in the reverse order,
starting with tile right half of the stainless
steel filter. Then screw in tile tower. Replace
the super fine filter over the tower by pressing
firmly on the outer edge until it (lips into
place and reposition the lower spray arm.
Reconnect the micro-mesh filter to the left
half of tile stainless steel filter prior to replacing
it ba(k into the dishwasher, Then replace the
glass trap. Ensure that all filters are repla(ed
_orre( tly for best resuhs.
f rip filter and lift
to remove
Perforated sta_
steel tilter
_ Micro-mesh filter
Squeezeclips to remove
micro-mesh filter
Pull super fine t
filter up to remove
Lift stainless stee
filter to remove
17