GE Monogram ZBD5900F01SS Use And Care Manual page 22

@estions ?
Use this
problem
SO[VeV
PROBLEM POSSIBLE CAUSE WHAT TO DO
Spots and filming on
glasses and flatware
Cloudiness on
glassware
Extremely hard
water
Low inlet water
temperature
Overloading tile dishwasher
Improper loading
Old or damp powder
detergent
Rinse agem dispenser
empV
Too little detergent
•Use a rinse agent to remove spots
and prevent new film buikl-up.
•To remove stubborn spots iiom glassware:
1 Remove all metal utensils flom tile
dishwasher.
2 Do not add detergent.
3 Select tile NORMAL WASH cycle
and HEATED DRY option.
4 Start the dishwasher and allow to run
until tile main wash.
5 Open tile door and pour 2 cups
(500 ml)ofwhite vinegar into the
bottom of tile dishwasher.
Combination of soft
water
alld too illll( h
detergent
Extended exposure
to high temperature
water
(;lose the door and allow to conlplete
the cycle. If vinegar rinse doesn't
work: Repeat as above, except use
1/4 cup (60 ml) of citric acid crystals
instead of vinegar.
•This is (:ailed etching and is permanent.
To prevent this flom happening, use less
detergent if you have soil water.
Wash glassware in the shortest cycle that
will get them clean.
•Lower the water heater temperature.
Black or ,gray •Remove marks with a mikl, abrasive
marks on dishes (leaner.
Dishes don't dry
Dishwasher won't run
Ahmfinum utensils haxe
rubbed against dishes
Low inlet water
temperature
Rinse agent dispenser
is empty
Fuse is bl(mu, or the
circuit breaker tripped
•Make sure inlet water temperature is
(orre(Tt.
•Depending on your model select WATER
TEMP B()OST & HEATED DRY or WATER
TEMP SANI and HEATED DRY options.
•Check tile rinse agent dispenser.
•Replace fllse or reset circuit breaker. Remove
any other applian( es from the (ir(uit.
•Try reseUing.
21