How To Fill Rinse Aid - Haier DW9-TFE1 Instructions For Use Manual

It is recommended that adjustments be made in accordance with the following table:
Water Hardness
Clarke
Level
degrees
1 0-14
2 14-36
36-71
3
4 >71

How to fill rinse aid

Rinse aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door.
When the low rinse aid indicator "
aid is low,you must load rinse aid .
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading the
rinse aid.
To open the dispenser, turn the
and then pour in the rinse aid, making sure not to overfill. The amount
of rinse aid used for each cycle can be regulated by turning the
dose adjustor, located beneath the
are 6 different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot-
ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white
streaks, turn the dosage adjustor to a lower setting.
Selector
ºdH mmol/l
position
0-17 0-1,7 /
18-44 1,8-4,4 "-"
45-89 4,5-8,9 Middle
>89 >8,9 "+"
1 " is bright ,it means the rinse
"2" cap in an anti-clockwise direction
"2" cap, with a screwdriver. There
Salt
Autonomy
c o n s u m p t i o n
(cycles/2kg)
(Grams/cycle)
0 /
20 60
40 40
60 25
Low
Full
"3"
en
1
2
3
8