End Of Programme; Switching The Dishwasher Off - Haier DW9-TFE1 Instructions For Use Manual

End of programme

Six beeps will indicate that the wash cycle has finished and the state indicators "A" light.

Switching the dishwasher OFF

Several minutes after the programme has ended:
Set On-Off button to Off
Open the door .
Remove dishes, etc. when they have cooled down.
Notice:
When the appliance is already underway press the button "B" for 3 seconds, all of the
settings will be cancelled.
Interrupping the programme
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep 10 times every 30 seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
Cancelling or modifying a cycle
A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, " Loading the
detergent ").
To cancel and restart the already ongoing program, follow the instruction on the page: 16 in the
section "Reset Drain Function". Then select the desired program (see also page 15 in the section
"Switching the dishwasher ON"
Reset drain function
You can use Reset drain function to stop the washing cycle under
running by Rotating the knob to "Reset ", and the appliance will stop
after a few minutes drain phase.
en
16