Wi-Fi Module - RBR duo3 C.T uv Manual

6.4 Wi-Fi module

Instruments equipped with a Wi-Fi module have the WI-FI READY icon on the end-cap.
This module needs to be enabled at the time of purchase.
Use the Wi-Fi module on your instrument to download the realtime data and process them while still at sea. There is no
need to open the instrument, and no need to be close to the shore as your instrument will be the router point.
When activated, the instrument will create its own SSID network which will appear under Wi-Fi networks on your
device. Your device will switch to this network and connect to the instrument. If set to Auto-download, Ruskin will start
downloading the data.
There are two ways to activate the Wi-Fi on RBR instruments: twist activation and pressure switch.
Twist activation
Activate the Wi-Fi by twisting the end-cap in either direction. The WI-Fi will stay on for 60 seconds, waiting for you to
connect. The instrument needs to be close enough for you to reach it and turn it on.
.
The Wi-Fi is disabled after 60s of inactivity. Twist the end-cap to RUN or PAUSE to re-activate the Wi-Fi.

...
Twisting the end-cap to the RUN or PAUSE position will activate the Wi-Fi. However, twisting to the PAUSE

position will also pause the instrument, as described above. Twist the end-cap back to RUN before continuing
with deploying your instrument.
...
RBR#0015699revB
Wi-Fi READY icon
Contact RBR if you have any questions about this feature.
20