Page 1
W4G WiFi Datalogger Setup Guide Overview The SOP document shows a step-by-step guide of setting up the latest Solis WiFi datalogger sticks. The note applies to the S2, S3 and S4 models of the dataller sticks. NB. It is very important to ensure the WiFi signal strength is good, see the WiFi Signal Strength section below.
Using the system with a signal strength below this low zone will not work correctly and will cause the following issues. 1. Inconsistent and slow system updates to Solis Cloud. 2. System firmware updates will not be possible and continuously fail.
Connection Method Step 1: On a WiFi enabled device find the AP with Step 2: Open a Internet Browser and brows to IP address Solis_xxxxxxxxxx and connect with the 10.10.100.254. At the web interface login screen use password: 123456789 u: admin | p: 123456789...
Page 4
Step 3: Once logged in to the web interface, select the Step 4: The below screen for WiFi will open and select Quick Set link the Search option.
Page 5
Step 5: Select the WiFi to use for the data connection Step 6: Once the correct WiFi is selected enter the and select the OK button. password for WiFi and select the Save option. Once the process is complete the logger will restart and connect to the access point.
Resetting the Datalogger Reset Procedure Once a WiFi connection has been established with the logger the AP gets hidden and you will no longer be able to logon to the logger stick again. In this case you will need to reset the logger to be able to reconfigure it. All the latest versions of the WiFi dataloggers have an external “Reset”...
Need help?
Do you have a question about the W4G and is the answer not in the manual?
Questions and answers