OptConnect mylo2 Quick Start Manual page 6

3. Place mylo2, connect antenna & power
• Place mylo2 in your equipment by attaching its magnetic
base to a metal surface.
• Route antenna leads to mylo2.
• Connect both antenna leads to mylo2 and fully tighten.
• Route power adapter's cord from power source to mylo2.
• Connect power cord to mylo2; ensure the green LED next
to the power port glows.
• After 10-60 seconds, ensure the middle green LED glows
or flashes.
IMPORTANT – when mylo2 powers up the first time it may
download a software update. This is indicated by a rapidly
flashing middle green LED light for 1-2 minutes followed by
the LED going dark while mylo2 reboots. You must allow
this process to complete.