OptConnect mylo2 Quick Start Manual page 12

9. Identify remote access ports for non-ATM
equipment
• mylo2 is configured for common remote access protocols
such as https, RDP, vnc, ssh, GoToMyPC, for two clients.
• Learn your preferred protocol's TCP/IP port number from a
manual or published resources, ex. https is port 443.
• Prepend a digit to the protocol's port number to reach
your equipment according to the table below where xxx is
the port number on which your equipment will respond:
To reach your equip on port xxx
192.168.1.11....................................
192.168.1.12....................................
• Ex: directing your browser to <mylo2 IP address> : 2443
establishes an https session on port 443 with your
equipment at IP address 192.168.1.12, the 2nd device in
the table above.
• mylo2 is pre-configured for remote access to two static IP
clients as per the table above. Contact our Customer Care
Center at 877.678.3343 for custom port configurations or
to support remote access for more than two clients.
Contact port
xxx
2xxx