Aiwa CX-NA222 Operating Instructions Manual page 6

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6iAA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
To
use
SHIFT
on the remote control
Buttons @) have two different functions, One of these functions
is intlcated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing SHIFT.
To use FUNCTION on the remote control
FUNCTION substitutes for the function buttons (TAPE DECK
1/2, TUNER BAND, VIDEO/AUX, CD) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically. When tapes are inserted in both decks, each deck is
selected with FUNCTION.
FUNCTION
m
If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
. The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
E
.—-. . .. .
8
To
turn the power on
Press one of the function buttons (TAPE, TUNER, VIDEO/AUX,
CD). Playback of the inserted disc or tape begins, or the
previously tuned station is received (Direct Play Function).
POWER is also available.
m
When the power is turned on, the disc compartment may open
and close to reset the unit.
To turn
the power
off
Press POWER.
Flash window
The window on the top of the unit lights up or flashes while the
unit is being powered on.
To turn off the light of the top window, press S while pressing
CD. To turn back on, repeat the above.
To
change the brightness level of the display
1
Press ENTER/DIMMER.
2 Within 4 seconds, turn MULTI JOG to select the dimmer mode
as below.
The mode will be automatically set after 4 seconds. It will also
be set if ENTER/DIMMER is pressed within 4 seconds after step
2,
DIM-OFF~AUTO-fXM* DlMMEf3 1-DIMMER 2
DIM-OFF: The normal display.
AUTO-DIM: If the unit is not used for 10 seconds, the illumination
of the display automatically becomes dimmer than DIMMER 2,
and the window on the top of the unit and the button lamps light
off
DIMMER
1:
The illumination of the display is dimmer than usual,
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1.
6
EfVGLK5H