Sharp CD-RW5000 Operation Manual page 39

Timer and Sleep Operation (continued)
6
Turn the jog dial to specify the minute and within 10 seconds,
press the ENTER button.
7
Turn the jog dial to specify the hour to stop and within 10 sec-
onds, press the ENTER button.
8
Turn the jog dial to specify the minute and within 10 seconds,
press the ENTER button.
Timer play: Go to step 10.
Timer recording: Go to step 9.
9
For timer recording, turn the jog dial to select "CD-R REC" or
"TAPE REC" and within 10 seconds, press the ENTER button.
10
Adjust the volume using the VOLUME buttons.
Do not turn the volume up too high.
11
Press the CD, CDR, TUNER (BAND) or TAPE button to select the
desired function.
To select the timer playback source : CD, CD-R/CD-RW, TUNER (BAND) or TAPE.
To select the timer recording source : TUNER (BAND).
*RW5000_P38_42(Advanced) 39
12
Press the POWER button to enter the timer stand-by mode.
To cancel the timer playback/timer recording:
1. Press the POWER button to turn the power on.
2. Press the MENU button.
3. Turn the jog dial to select "TIMER OFF" and then press the ENTER button.
To check the setting time:
1. Press the POWER button to turn the power on.
2. Press the MENU button.
3. Turn the jog dial to select "TIMER PLAY" or "TIMER REC" and then press
the ENTER button.
4. Press the POWER button to enter the timer stand-by mode.
13
When the preset time is reached, playback or recording will start.
The volume will increase gradually until it reaches the volume you were lis-
tening to before turning off your system.
14
When the timer end time is reached, the system will enter the
power stand-by mode automatically.
If you press the CD CDR, TRACK EDIT, FINALIZE, ERASE or MENU button
during timer operation, the timer mode will be cancelled and playback or
recording will last even when the end time is reached.
Notes:
The system will be turned on 2 minutes (no operation can be accepted during that
time.) before the timer playback and recording preset time to prepare for them.
Actual playback and recording will start from the set time.
When performing timer playback or recording using another unit connected to the
AUX IN jacks, select "AUX" in step 11. At this time, only this stereo system will be
turned off automatically. (Another unit will not be turned off.)
To change the setting time:
Perform "Timer playback/Timer recording" from the beginning.
00.7.14, 11:29 AM
39