Sharp CD-RW5000 Operation Manual page 29

Recording to a CD-R/CD-RW (continued)
In steps 8 - 9, operate within 5 seconds. Otherwise, the system will go to the next step
automatically.
For just checking, perform step 7 only.
To change the setting, follow the procedure.
7
Press the CD CDR button.
8
Select "AUTO" using the jog dial to finalize the disc. Then press
the ENTER button.
AUTO : Automatically finalizes the disc after recording.
MANUAL : Does not finalize the disc. Refer to page 36 for manual finalizing.
(An unfinalized disc cannot be played on a CD player.)
9
Select "HIGH" using the jog dial to record at high speed. Then
press the ENTER button to start recording.
HIGH : High speed recording.
NORMAL : Normal speed recording.
You can also change the recording speed using the HIGH/NORMAL button.
When the CD reaches the end, recording will stop.
*RW5000_P27_37(CD-R) 29
"OVER" indication in step 9:
If the recording time is longer than the recordable time of the CD-R/CD-RW disc, "OVER"
appears. Then, the system displays the following information.
Exceeding number Exceeding time
of tracks
You can record only the "recordable tracks" by pressing the CD CDR button again.
Adjusting the recording level:
You can lower the level if the level of the recording source is high.
During recording or while recording is paused, adjust the recording level using the
3 or 2 button.
–63
Note for high speed recording:
High speed recording is possible only during digital recording.
If the CD-R/CD-RW disc you record from is copyright-protected by the SCMS (page
27), the system will perform analog recording automatically.
The disc will be recorded at normal speed.
To stop recording:
Press the button.
The CD and CD-R/CD-RW disc will stop.
After use:
Press the POWER button to enter the power stand-by mode.
Note:
The unit may take longer to shut off depending on the condition of the CD-R unit.
00.7.19, 9:29 AM
Recordable Recordable time
tracks
0
29