Sharp CD-RW5000 Operation Manual page 44

Troubleshooting Chart (continued)
CD-R/CD-RW recorder
Messages for CD-R/CD-RW disc loading
Message
? DISC
CDR NO DISC
OPC ERROR
NOT AUDIO
Messages for CD-R/CD-RW disc recording or editing
Message
COPY PROTECT
CAN'T COPY
CAN'T REC
DISC ERROR
DISC FULL
FINALIZED CD
NO SIGNAL
44
*RW5000_P43_47(References) 44
Possible cause
A disc other than an audio CD-R disc is
loaded.
No disc is loaded.
Cannot read the CD-R disc.
(A CD-R disc cannot be read if loaded.)
The disc is not an audio one.
Possible cause
A copy prohibited signal was found by the
SCMS. (See page 27.)
Error occurred during recording.
Error occurred during recording or editing.
No space left on the CD-R.
Performed recording or editing on a final-
ized CD-R.
If it is a CD-RW disc, it can be unfinalized.
(See page 36.)
No signal is sent from the cable (AUX OPT.
terminal).
If trouble occurs (reset)
When this product is subjected to strong external interference (mechanical shock, ex-
cessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is oper-
ated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1. Press the POWER button to enter the power stand-by mode.
2. While pressing down the VOLUME X X X X X button, press the POWER button un-
til "ALL CLEAR" appears.
Caution:
This operation will erase all data stored in memory including clock and timer settings,
and tuner and CD presets.
Before transporting the unit
Remove the CD-R/CD-RW disc and all CDs from the unit. Your unit checks whether
there are any discs inside the unit when the tray is closed. "CDR NO DISC" and "CD
NO DISC" appear if no disc is left. Then, set the unit to the power stand-by mode.
Carrying the unit with discs left inside can damage it.
00.7.13, 3:18 PM
and