Sharp CD-RW5000 Operation Manual page 24

Listening to the Radio (continued)
Preset tuning
You can store 40 AM and FM stations in memory and recall them at the push of a
button.
1
Perform steps 1 - 4 in the "Tuning" section on page 23.
2
Press the ENTER button to enter the preset tuning saving mode.
3
Within 5 seconds, turn the jog dial to select the preset channel
number.
Store the stations in memory, in order, starting with preset channel 1.
When is displayed, a station has already been stored in memory.
4
Within 5 seconds, press the ENTER button to store that station in
memory.
If the "MEMORY" and preset number indicators go out before the station is
memorized, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset
station.
When a new station is stored in memory, the station previously memorized
will be erased.
Note:
The backup function protects the memorized stations for a few hours should there be
24
a power failure or the AC power cord disconnection.
*RW5000_P18_24(Playback) 24
To recall a memorized station
Turn the jog dial to select the desired station.
Note:
The PRESET (X or W) button on the remote control allows you to recall a memorized
station.
Preset memory scan
The stations saved in memory can be scanned automatically.
1
To scan the preset stations, press the PRESET (X X X X X or W W W W W ) button
on the remote control for more than 0.5 seconds.
The preset number will flash and the programmed stations will be tuned in
sequentially, for 5 seconds each.
2
Press the PRESET (X X X X X or W W W W W ) button again when the desired sta-
tion is located.
To erase all the contents of the preset memory
1. Press the TUNER (BAND) button.
2. Press the ENTER button.
3. Press the CLEAR button on the remote control.
4. Press the ENTER button.
To erase only one station:
Recall the memorized station. While it is displayed, press the CLEAR button on the
remote control, then press the ENTER button.
00.7.13, 3:15 PM