Sharp CD-RW5000 Operation Manual page 26

Recording to a Cassette Tape (continued)
26
*RW5000_P25_26(Recording) 26
Recording from the radio
1
Tune in to the desired station. (See page 23.)
2
Load a cassette into the compartment with side A facing you.
3
Press the REV. MODE button to choose a recording mode, one
side or both sides.
.... To record on both sides.
.... To record on only one side.
4
Press the TAPE REC button repeatedly to switch to the side you
record on.
Recording will be paused.
To record on both sides, begin on side A. (If recording is started from side B,
the tape will not switch over to side A.)
5
Press the 06 06 button to record on side A, or the 1 1 1 1 1 button for
06 06
06
side B.
When you press the 06 button on the remote control, the system will record
on the side specified in step 4.
To interrupt recording:
Press the TAPE REC button.
To resume recording, press the same recording button you pressed in step 5. Other
buttons do not allow resuming.
To stop recording:
Press the button.
Note:
If you hear a whistling noise while recording an AM station, move the AM loop antenna.
Erasing recorded tapes
1. Press the TAPE button.
2. Follow steps 2 - 5 in "Recording from the radio".
00.7.13, 3:15 PM