RH Baby&child RH TEEN MADERO Assembly Instructions

MADERO FULLY UPHOLSTERED BED - FULL - ASSEMBLY INSTRUCTIONS
PARTS INCLUDED
A [1] HEADBOARD
B [2] SIDE RAILS
C [1] FOOTBOARD
D [1] SUPPORT RAIL
E1 [1] PLATFORM PANEL 1
E2 [1] PLATFORM PANEL 2
IMPORTANT SAFETY INSTRUCTIONS
Please read all instructions carefully before assembling.
1.
For your safety, assembly by two or more adults is strongly recommended.
2.
Keep instructions for future use.
3.
Use only vendor-supplied hardware to assemble. Using unauthorized
4.
hardware could jeopardize the structural integrity of the item.
ASSEMBLY INSTRUCTIONS
1. Place the headboard (A) upright in the position you wish the bed to be in when fully assembled.
2. There is a removable block at the bottom of the headboard. Use the Allen wrench (6) to loosen the bolt if you want remove it. See FIGURE 1A.
3. Secure the threaded rod (1) to the fixed nut on the headboard (A) by simply turning it manually.
4. Raise the side rail (B) up and place the rod (1) to align with the bore holes on the end of the side rail (B). Put the side rail (B) up against the headboard
(A) so the threaded rods (1) go through the bore holes. Insert curved washer (2), lock washer (3) and place hex nuts (4) on threaded rod (1) then
tighten the hex nuts (4) with wrench (5), as illustrated in FIGURE 1B.
5. Repeat the above procedure with the other side rail (B) to attach it to the headboard (A), and then repeat to connect side rails (B) to the footboard (C).
2
3
4
5
FIGURE 1B
E1
E2
D
C
1
1
HARDWARE INCLUDED
A
NO. SKETCH
1
2
B
3
4
5
6
Removable
block
4
FIGURE 1A
DESCRIPTION SPECIFICATION
Threaded Rod
M8 x 100mm
Curved Washer
15 x 8.5 x 2mm
Lock Washer
Ø14 x Ø9 x 2mm
Hex Nut M8 x H15 x D14mm
D14.5 x 100mm
Spanner Wrench
110 x 28 x D4mm
Allen wrench
(K4)
F i g . 1 B
F i g . 1 A
QTY.
8 pcs.
8 pcs.
8 pcs.
8 pcs.
2 pcs.
1 pc.
1 3 /