Adjusting Bass And Treble - Pioneer Elite VSX-35TX Operating Instructions Manual

Basic Playback

Adjusting Bass and Treble

You can use BASS +/– or TREBLE +/– buttons to adjust the low and high frequencies for each individual set of
speakers. If the receiver is in STEREO mode you can only adjust the FRONT speakers. In a surround mode
(STANDARD, ADVANCED THEATER, etc.) you can adjust the FRONT, CENTER, SURROUND and SURROUND
BACK speakers. The TONE button can also be used to bypass the tone circuitry (see p.23).
2
1
50
1 Press the TONE button on the front panel to
3
2 Press the CHANNEL SELECT button on the
3 Use the BASS or TREBLE (+/–) buttons to
memo
put the receiver in tone TONE ON mode.
front panel to cycle through the different
tone adjust modes.
The button cycles though the possibilities in the following
order:
TONE Front
TONE SurrBack
When not using SURROUND BACK speakers:
TONE Front
TONE Surround
adjust the low or high frequencies of each
channel.
A few seconds after you finish adjusting the tone the receiver will
revert to the sound mode it was in at the beginning of the
process.
• The tone control can be adjusted in a range of ±6 dB.
• The tone control cannot be adjusted in THX and MULTI CH
IN modes.
• When you press the TONE button in DIRECT mode the re-
ceiver switches to STEREO mode and "TONE ON" appears
in the display. You can now change the TONE setting (note
the receiver is no longer is DIRECT mode).
TONE Center
TONE Surround
TONE Center