Switching Analog And Digital Signal Input - Pioneer Elite VSX-35TX Operating Instructions Manual

Switching Analog and Digital Signal Input

This switch moves the input fed to the receiver between analog and digital sources. You need to take special
care to switch to the appropriate input, when necessary. For example, the switch would have to be on DIGITAL
to use DOLBY DIGITAL or DTS surround sound but it would have to be on ANALOG to record to the analog out
jacks on the receiver. The default setting is AUTO (priority is given to a digital signal, if there is one).
Î
USE SETUP
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
VCR 1/
DVD/LD TV/SAT VCR2
DVR
MULTI CONTROL
CD-R/
CD TUNER TV CONT
TAPE 1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
- + - +
TUNING STATION
1 ¡ 4 ¢
- +
DTV ON/OFF DTV MENU CHANNEL
1 2
3
4 5 6
7 8 9
GUIDE EXIT
0
ENTER
+10 DISC
+ +
TV
TV VOL TV CONTROL VOLUME
– –
TV FUNC
REMOTE SETUP
INPUT
MENU MUTE
ATT
SYSTEM SETUP
+
EFFECT/ FUNCTION
CH SEL
ENTER
DIGITAL SIGNAL
–
NR SELECT
MULTI CH STEREO/
DSP
MIDNIGHT
INPUT DIRECT
/DTS
LIGHT THX ADVANCED STANDARD
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
memo
• In the AUTO setting , SIGNAL SELECT chooses the signal in the following order: DIGITAL, ANALOG.
• If the Digital-In Select (see p. 30) choices are set to OFF, the SIGNAL SELECT will default to ANALOG.
• Because the audio from a karaoke microphone and LD recorded with analog audio only is not output from
the digital output, set SIGNAL SELECT to ANALOG.
• This receiver can only playback Dolby Digital, PCM (32kHz, 44kHz, 48kHz, and 96kHz), and DTS digital
signal formats. If you have some equipment that outputs digital audio in a format other than these you'll
have to connect and playback via the receiver's analog inputs (make sure that SIGNAL SELECT is set to
ANALOG).
• When an LD or CD with DTS is played back with the SIGNAL SELECT set in ANALOG, digital noise caused
by playing back the DTS directly (with no decoding) is output. To prevent noise, you need to make digital
connections (See p. 13 - 15) and set SIGNAL SELECT to DIGITAL or AUTO.
• The levels between analog and digital sources may vary so be careful with volume levels when switching
between these two.
1 Put the remote control slide switch in USE.
1
2 Press the SIGNAL SELECT button to select
the input signal corresponding to the
source component.
Each press switches the signal in the order below:
3 While SIGNAL SELECT is set to DIGITAL lights
when a Dolby Digital signal is input, DTS
lights when a DTS signal is input.
2
ANALOG
AUTO
DIGITAL
Basic Playback
When a DTS signal is
input.
When a Dolby Digital
signal is input.
47