Switching Analog/Digital Signal Input - Pioneer VSX-D409 Operating Instructions Manual

Sound Modes
Switching ANALOG/DIGITAL Signal Input
\Vhen you select a function (for example, CD) that is only hooked up by a digital connection, then the ANAL
VSX-D509S/D509S-G
1
2
3
Press RCV.
This switches the remote to the surround setup mode. (On the
D409/D409-G the button is called RECEIVER.)
Press SIGNAL SELECT to select the input
signal corresponding to the source
component.
Each press switches between ANALOG and DIGITAL signal sel
tion.
While SIGNAL SELECT is set to DIGITAL, 0
DIGITAL lights when a Dolby Digital signal
input, DTS lights when a DTS signal is inpt
Each press switches between
ANALOG and DIGITAL signal selection.
'SIGNAL
BELECT
When a DTS
signal is input.
'SIGNAL,
SELECT
SIGNAL,
SELECT. Pee
ANAL
When a Dolby Digital
signal is input.
SIGNAL,
'SELECT
sp orerraif.
pjocoaraly
| memo
.
SIGNAL SELECT «
oce
=|
i j= SoODDoooOo
Sy:
: } |meeazea
36
En
SIGNAL SELECT is fixed in the "ANALOG" position for compon
not assigned to one of the two digital input jacks.
This receiver can only play back Dolby Digital, PCM (82kHz, 44ki
and 48kHz), DTS, digital signal formats. With digital signal forme
other than these, set SIGNAL SELECT to "ANALOG".
When an LD or CD player compatible with DTS is played back v
SIGNAL SELECT set in "ANALOG", digital noise is output cause
playing back the DTS directly (no decoding). To prevent noise, yc
need to make digital connections (Refer to page 10) and set SIG
SELECT to "DIGITAL".
Some DVD players don't output DTS signals. For more details, re
to the instruction manual supplied with your DVD player.