Denon AVR-3311 Owner's Manual page 83

ENGLISH
Manual Setup
Setting items
Speaker Config. Subwoofer : Set the presence of a subwoofer.
(Continued) • Yes : Use a subwoofer.
• No : Select when a subwoofer is not connected.
When "Front" is set to "Small", "Subwoofer" is automatically set to
"Yes".
Surround : Set the presence and size of the surround speakers.
• Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the surround speakers are not connected.
• When "Surround" is set to "Large", "S.Back", "F.Height" and "F.Wide"
can be set to "Large".
• When "Surround" is set to "None", "S.Back", "F.Height" and "F.Wide"
can automatically set to "None".
S.Back : Set the presence, size and number of surround back speakers.
• Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the surround back speakers are not connected.
• 2spkrs : Use two surround back speakers.
• 1spkr : Use only one surround back speaker. When you select this
setting, connect the surround back speaker to the left (L) channel.
Even when the "S.Back" setting is other than "None", sound may
not be emitted from the surround back speaker, depending on the
playback source. In this case, make "Surround Parameter" – "S.Back"
setting other than "OFF" (vpage 74).
NOTE
When "Amp Assign" setting (vpage 79) is other than "Normal", you
cannot make the "S.Back" setting.
F.Height : Set the presence and size of the front height speakers.
• Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the front height speakers are not connected.
NOTE
When "Amp Assign" setting (vpage 79) is other than "Normal", you
cannot make the "F.Height" setting.
80
Remote control operation
buttons
Setting details
Move the cursor
(Up/Down/Left/Right)
Setting items
Speaker Config. F.Wide : Set the presence and size of the front wide speakers.
(Continued) • Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the front wide speakers are not connected.
NOTE
When "Amp Assign" setting (vpage 79) is other than "Normal", you
cannot make the "F.Wide" setting.
Bass Setting Subwoofer Mode : Select low range signals to be reproduced by
Set subwoofer and LFE subwoofer.
signal range playback. • LFE : The low range signal of the channel set to "Small" speaker size is
added to the LFE signal output from the subwoofer.
• LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer.
• "Subwoofer Mode" can be set when "Speaker Config." – "Subwoofer"
(vpage 80) is set to "Yes".
• Play music or a movie source and select the mode offering the strongest
bass.
• Select "LFE+Main" if you want the bass signals to always be produced
from the subwoofer.
NOTE
If "Front" and "Center" for "Speaker Config." are set to "Large", and
"Subwoofer Mode" is set to "LFE", no sound may be output from the
subwoofers, depending on the input signal or selected surround mode.
LPF for LFE : Set LFE signal playback range.
• 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz
Distance Unit : Set the unit of distance.
Set distance from listening • Feet / Meters
position to speakers.
Step : Set the minimum variable width of the distance.
Measure beforehand the
• 1ft / 0.1ft
distance from the listening
• 0.1m / 0.01m
position to each speaker.
Front L / Front R / Center / Subwoofer / Surround L / Surround R /
z
S.Back L / S.Back R
: Select the speaker.
z When the "Speaker Config." – "S.Back" setting (vpage 80) is set to
"1spkr", "S.Back" is displayed.
• 0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.
Confirm the setting
Setting details
z
/ F.Height L / F.Height R / F.Wide L / F.Wide R
Return to previous menu