Environmental Protection Description; Basic Parameters - Roborock Q5 DuoRoller+ User Manual

Environmental
Protection Description
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution.
Before disposing of this product, remove
the battery. The battery should then be
properly recycled either through local
authorities or by providing the batteries to a
battery recycling facility.
How to remove the battery:
Note: The following information is only suitable for the
situation that the robot will be disposed of or its battery
cannot function normally after recharging.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the clip to pull out the battery connector.
6. Remove the battery.
Notes:
• Before removing the battery, make sure it is fully
drained. Do not attempt to remove the battery if the
robot is connected to the charging dock.
• Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage
of hazardous substances.
• In the event of accidental contact with battery fluid,
rinse thoroughly with water and seek immediate
medical care.

Basic Parameters

Robot
Model Q50ULE
14.4 V/5200 mAh (TYP)
Battery
lithium-ion battery
Rated Input 20 V 1.2 A
Charging Time < 6 hours
Note: The serial number is on a sticker on the
underside of the robot.
Auto-Empty Dock
Model AED06LRR, AED07LRR
120 V
~
Rated Input Voltage
50-60 Hz
Rated Frequency
9.5 A
Rated Input (Dust Collection)
Rated Input (Charge)
0.5 A
Rated Output 20 V
12
1.2 A