Environmental Protection Description; Holiday Energy Saving Function - Roborock Flexi Pro User Manual

Environmental Protection Description

Removing the Battery
* The following information applies only when disposing of the vacuum cleaner and should not be followed for day-to-day operations.
The chemical substances contained in the built-in lithium-ion battery of this product can cause environmental pollution. Remove the battery
before disposing of this product and hand it to a professional battery recycling facility for centralized disposal.
How to remove the battery:
1. Remove the handle and remove the clean tank and dirty tank at the same time.
2. Unscrew 1 screw below the top rear cover and remove the top rear cover.
3. Unscrew the 6 screws on the bottom rear cover, and then unscrew the 6 screws on the front cover.
4. Disconnect the contacts on the motherboard and remove the battery.
Notes:
Before removing the battery, make sure it is fully drained. Do not attempt to remove the battery if the vacuum cleaner is connected to the dock.
When unpluging the circuit board cord, avoid positive electrodes touching with negative ones to prevent causing short circuits.
Remove the entire battery pack. Avoid damaging the battery pack casing to avoid short-circuits or leakage of hazardous substances.
In the event of accidental contact with battery fluid, rinse thoroughly with water and seek immediate medical care.

Holiday Energy Saving Function

In holiday mode the device will switch to Low Power mode to minimize power consumption. This includes dimming of the LED indicator, and
the stopping of all non-charging related functions including cleaning, remote control over WiFi, and more.
To activate holiday mode, firstly, remove the wet and dry vacuum cleaner from the charging dock and turn it off. Secondly, press and hold
the Change Mode button and at the same time, put the vacuum back to the dock and wait 10 seconds until hear "ticktack" then release the
button. The wet and dry vacuum cleaner, main unit and charging dock will enter holiday mode.
To deactivate holiday mode, you need two steps:
1. Remove the wet and dry vacuum cleaner from the charging dock and press and hold the Power button for 10 seconds.
2. Unplug the power cord and reconnect.
13