Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for FAAC A952
Summary of Contents for FAAC A952
- Page 1 P a g e...
- Page 2 40mm of Hardwood, 6/10mm of Aluminium or 6mm of Steel are suitable mounting requirements. STEP 3 Once the operator and arm are mounted to the header and door, wire main power to the A952 as below. Introduce the Motor -Encoder -Power plugs into the Control Unit Install the terminal board plastic protective cover.
- Page 3 STEP 4 The A952 uses an on-board programming system comprising of a display and function buttons. The display is inverted by using J25 to display the correct way up depending whether it is mount on a R/H or L/H door.
- Page 4 Partial Stop Sec, Enable. Enabling Partial Stop Sec when using the XPB ON’s, you will need to re-run Setup so that the A952 can identify where Opening Stop Safety will be triggered to allow the inhibiting angle to be set.
- Page 5 STEP 3 Plug the KP EVO into the operator that you designate to be the Secondary (i.e. not receiving the opening commands). Using the KP EVO, go to Spanner, Programming and then into Intercom (see below) and perform the following configuration changes.
- Page 6 Notes P a g e...
Need help?
Do you have a question about the A952 and is the answer not in the manual?
Questions and answers