FAAC A951 Quick Start

Hide thumbs Also See for A951:

Download this manual

These instructions are to be considered as a rapid guide for installation of the FAAC A951 for

both a single door installation or double door installation with On Door Safety Sensors and a

check for opening/closing speeds along with the Hold Open time. We have included references

where to find relevant wiring information for the fitting of Safety Sensors to protect the swept

area of door/doors as specified by specified by the Risk Assessment undertaken by the

installer. The installer should still familiarise themselves with the full manual and the safety

information

contained

within.

(available

https://www.faac.co.uk/door/swinging-

doors/951-swing-door-operator)

P a g e

| 1

Page 1 These instructions are to be considered as a rapid guide for installation of the FAAC A951 for both a single door installation or double door installation with On Door Safety Sensors and a check for opening/closing speeds along with the Hold Open time. We have included references...
Page 2 If for any reason, this is not available please refer to the A951 manual and pages 12 through to 13 for the mounting holes positions.
Page 3 Installation, Partial Stop Sec, Enable. Enabling Partial Stop Sec when using the XPB ON’s, will need to re-run Setup so that the A951 can identify where Opening Stop Safety will be triggered to allow it to switch to Low Energy Creep Mode.
Page 4 (See below) are identical between the two A951 operators. STEP 2 Link the two A951’s together using a 3-Core Cable (ideally Shielded, CAT5e as used for the KP Evo is suitable). Please ensure to check that DIPSWITCH “1” and “2” are in the “ON” position in both the Master and Slave operator.