FAAC 950N2 Quick Start Manual

Download this manual

These instructions are to be considered as a rapid guide for installation of the FAAC 950N2 for

both a single door installation or double door installation with On Door Safety Sensors and a

check for opening/closing speeds along with the Hold Open time. We have included references

where to find relevant wiring information for the fitting of Safety Sensors to protect the swept

area of door/doors as specified by specified by the Risk Assessment undertaken by the

installer. The installer should still familiarise themselves with the full manual and the safety

information

contained

within.

(available

https://www.faac.co.uk/door/swinging-

doors/950-swing-door-operator)

P a g e

| 1

Page 1 These instructions are to be considered as a rapid guide for installation of the FAAC 950N2 for both a single door installation or double door installation with On Door Safety Sensors and a check for opening/closing speeds along with the Hold Open time. We have included references...
Page 2 (See below). Please use this template for the position of the mounting holes, both for the operator and the arm. If for any reason, this is not available please refer to the 950N2 manual and pages 13 through to 16 for the mounting holes positions.
Page 3 STEP 5 Now perform a Setup on the 950N2 by holding SW1 on the I/O Board (See below). Hold the button until DL2 above starts flashing repeatedly. Please note that a SETUP can only be complete if the unit is in Automatic Mode (toggle switch on the side in the “0” position or main screen on KP Evo displaying “Auto Bi Dir”...
Page 4 If you are installing the operators on a double door, for the best result you will need to enable the Master/Slave functionality of the 950N2. In order to do this, you will require the use of a KP Evo as it is NOT POSSIBLE to achieve this otherwise under normal conditions.