Denon AVR-391 Owner's Manual page 39

ENGLISH
• If no button is operated for about 5 seconds, the display is returned to the normal display. After registering, the display is returned to the normal display.
Tone
Default settings are underlined.
Adjust the tonal quality of the sound.
Press .
1 TONE
ToneControl•OFF–
2 Use o p to select "ON".
ON : Allow tone adjustment (bass, treble).
OFF : Playback without tone adjustment.
NOTE
The tone cannot be adjusted in the direct
mode.
3 Press to select an item to be set, and use
TONE
to select a setting value.
Bass : Adjust low frequency range (bass).
• –6dB – +6dB (0dB)
Treble : Adjust high frequency range (treble).
• –6dB – +6dB (0dB)
"Bass" or "Treble" can be set when "Tone Control" is set to
"ON".
36
Remote control operation
buttons
NIGHT MODE
Optimized setting for late-night listening.
Press to select your desired
NIGHT
mode.
D.Comp : OFF
OFF : Not set.
Low : Set the adjusted value to "Low".
Mid : Set the adjusted value to "Middle".
High : Set the adjusted value to "High".
When a Dolby TrueHD signal is output, "DRC" is displayed on the
display of the main unit.
The setting mode is also changed as shown below.
o p
• OFF : Not set.
• Low : Set the adjusted value to "Low".
• Mid : Set the adjusted value to "Middle".
• High : Set the adjusted value to "High".
• Auto : Automatic dynamic range compression on/off control
according to the source.
Move the cursor
(Up/Down/Left/Right)
RESTORER
Default settings are underlined.
Compressed audio formats such as MP3, WMA (Windows Media
Audio) and MPEG-4 AAC reduce the amount of data by eliminating
signal components that are hard for the human ear to hear. The
RESTORER function generates the signals eliminated upon
compression, restoring the sound to conditions near those of the
original sound before compression. It also corrects the sense of
volume of the bass to obtain richer sound with compressed audio
signals.
Press
"OFF".
ON : Use RESTORER.
OFF : Do not use RESTORER.
• This item can be set with analog signals or when a PCM signal (fs =
44.1/48 kHz) is input.
• This cannot be set when the surround mode is set to "DIRECT".
• This item default setting for "iPod" is "ON". All others are set to
"OFF".
• When set to "ON",
Audio Delay
While viewing video, manually adjust the time to delay audio output.
Press
1
Use o p to select the value to be
2
set and then press
the setting.
0ms – 200ms
Store "Audio Delay" for each input source.
Confi rm the setting
Adjusting the sound fi eld effects
to select "ON" or
RESTORER
RESTORER: ON
is displayed.
Default settings are underlined.
.
AUDIO DELAY
A.Delay :• 0ms–
to enter
ENTER
Return to previous menu