Table of Contents
Advertisement
Install two mast mount clamps on the 4-inch ¼-20 hex head bolts as shown in
Step 7
Install a ¼-20 split lock washer and hex head nut on each bolt and tighten hand tight.
Step 8
Go to Step 1 and assemble the second mounting bracket.
Step 9
Figure 1
0 1
1
1
2
3
4
Attaching the Mounting Brackets to the Antenna
The antenna has studs onto which you attach the installed mounting brackets to it. The adjustable bracket
is installed on the top set of studs. Follow these steps to attach the mounting brackets to the antenna.
Step 1
Position the antenna so that the arrow on the orientation label is pointed up. The arrow points to the top
of the antenna so that it can be installed correctly.
Note
Step 2
Attach the adjustable mounting bracket to the top set of mounting studs.
Step 3
Install two split lock washers and hex nuts on the studs. Use a 7/16-in. socket or wrench to tighten the
nuts. Do not overtighten.
Step 4
Attach the non-adjustable mounting bracket on the bottom set of mounting studs.
Step 5
Install two split lock washers and hex nuts on the studs and tighten as described in Step 3.
Cisco Aironet 14-dBi Vertically Polarized Sector Antenna (AIR-ANT2414S-R)
6
Mounting Bracket Assembly
7
2 3
4 5
6 7
8
2
3
Antenna bracket (adjustable bracket shown)
¼-20 x ¾-in (1.9 cm) hex head nut
Mast mount clamp plate
Mast mount clamp
The orientation label is located on the back panel of the antenna.
6
5
4
4
5
Hex head bolt
6
¼-20 x ¾-in (1.9 cm) hex head bolt
7
¼-20 x 4-in hex head bolt details
Figure
1.
78-16403-01
Advertisement
Table of Contents
