Create Wind Flat Assembly Manual page 14

7
Once connected, place
piece P screwing it until it
is well tighten.
10
Connect the N wire from the
driver with the neutral wire
from your house wiring.
13
Once fitted, turn piece A to the right.
14
ENGLISH
8
O
Then, you have to join the re-
maining wires of piece B and
the line and neutral wires
from your house wiring in the
block terminal in piece L, as
shown below.
11
Make sure the wires aren't
pinched.
14
9
Connect the L wire from the
driver with the LINE wire
from your house wiring.
12
Slide part A up to fit the
screws protruding
piece L.
15
L
A
from