Air Flow Direction Adjustment - Haier HPU-18H03 Operation Manual

Operation
FAN speed display
When adjusting FAN speed during system operation, every time the FAN button is pressed,
fan speed changes as follows:
After setting the fan speed, the fan speed display on the operation panel will quit after blinking 5 seconds,
then the operation panel will display the indoor temperature.In case the air-flow model is in motion, touch
the air circulation button on the operation panel, the fan speed display will blink for 5 seconds, and the sign
" " of air-flow model will keep bright, while the '1'. '2'. '3' sign will disappear.
TEST OPERATION
Use this switch in the test operation when the room temperature is less 16
do not use it in the normal operation.
Unit start
Continue to press the ON/OFF button for more than 5 seconds.
After you hear the " Hua " sound twice,release your finger from the switch,
the test operation startsand the air conditioner starts with the air flow speed
setting "Hi".
Unit stop(to cancel test operation)
Push the ON/OFF button
If you use the remote controller to cancel the test run, the conditioner will then run
per the working mode displayed on the remote controller.

Air Flow Direction Adjustment

vertical flap
The Swing button on the remote controller, once been touched, the swing mode of the plastic
flap and the horizontal louver will be changed following the formula below:
plastic flap swings--- plastic flap stop--- horizontal louver swings--- horizontal louver stop
--- both swings--- both stop
AUTO LO
or operate with remote controller to cancel the test run.
17
MED HI
louvers
,
o
C