Haier HPU-18H03 Operation Manual page 17

Operation
TIMER On-Off Operation
Control panel
RemoteController
E.HEAT
Set clock correctly before starting TIMER operation.
1. After unit starts, select your desired operation mode.
Operation mode will be displayed on LCD.
2. Timer mode selection
Press TIMER button to change TIMER mode. Every
time the button is pressed, display changes as follows:
Remote controller:
Then select your desired TIMER mode (TIMER ON or
TIMER OFF). "
3. Time setting
Press HOUR /
Every time the button is pressed, time setting
increases 10min, if kept depressed, it will increases
rapidly.
Every time the button is pressed, time setting
decreases 10min, if kept depressed, it will decreases
rapidlly.
It can be adjusted within 24 hours.
4. Time confirming for TIMER ON
After setting correct time, press TIMER button to confirm.
" " on the remote controller stops flashing.
" " starts flashing.
Time displayed: Unit starts or stops at x hour x min.
5. Time setting for TIMER OFF
Just press HOUR button, follow the same procedure in
"Time setting for TIMER ON ".
6. Time confirming for TIMER OFF
After time setting, press SET button to confirm.
" " on the remote controller stops blinking.
Time displayed: Unit stops at X hour X min.
To cancel TIMER mode
Just press TIMER button several times until TIMER
mode disappears.
According to the Time setting sequence of TIMER ON
or TIMER OFF, either Start-Stop or Stop-Start can be
achieved.
16
" will flash.
button.