Dry Operation - Haier HPU-18H03 Operation Manual

Operation

DRY Operation

Control panel
Remote Controller
E.HEAT
COOL operation starts when room
temp. is higher than temp. setting.
Temp. setting+2 C
Temp. setting
On reaching temp. setting +2°C,
unit will run in mild DRY mode.
1.Unit start
Press ON/OFF button on the indoor unit or press ON/OFF
on the remote controller, unit starts.
The liquid crystal will display the working state of last
time (Expcept Timer, Sleep ).
2. Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
Control panel:
Then
3.Select temp.setting
Press TEMP. button.
Every time the button is pressed, temp. setting
increases 1°C , if kept depressed, it will increase
rapidly.
Every time the button is pressed, temp. setting
decreases 1°C , if kept depressed, it will decrease
rapidly.
4. Fan speed selection
Press FAN button. For each press, fan speed changes as
follows:
Remote controller:
Air conditioner is running under displayed wind speed.
In DRY mode: (1)When room temperature becomes 2°C
higher than temp. setting, unit will run at setting at Temp..
speed regardless of FAN setting; (2)When room temperature
Ultra-low air flow
becomes between temp. setting and temp.setting+2°C,
unit will run at setting at LO; (3) When room temperature
becomes lower than temp. setting, unit will run
with 10 minutes
5. Units top
Press ON/OFF button, the unit stops.
11
Select DRY operation.
ON and 6 minutes
spasmodically
OFF .