Server IxD Series Manual page 16

Troubleshooting
Problem
Unit is dis- Connected bottle/jug is not in the correct loca-
pensing wrong tion.
product.
The numbers don't match on both sides of the
tubing in the back of the unit.
Tubing is Bottle tubing is connected in the wrong location.
kinked outside
of bottle/jug.
Bottle/jug The wrong length tubing was selected.
tubing will
not reach
connector.
Product is Tubing connections are not secure.
coming from
locations
inside unit.
Support Videos
Setup Video
http://server-products.com/flavor-setupvideo.htm
How to Use Video
http://server-products.com/flavor-howtousevideo.htm
How to Clean Video
http://server-products.com/flavor-howtocleanvideo.htm
16
Problem Cause Solution
Ensure bottle/jug is in the proper location.
In the back of the unit, ensure the numbers
match on both ends of the tube.
Place bottle tubing in different location or
connect to a higher connection. Replace tubing
if seeing a kink after moving location.
The unit comes with multiple length tubing for
different locations. Change bottle tubing to
lower bottle location.
Remove side panel to investigate. May need to
reconnect tubing or send in for service.