Server IxD Series Manual page 12

Detailed Assembly & Setup Instructions
24
If cleaning more lines, prep the
sanitizing solution container and
place an empty container under
the dispense point to receive
the flushed solution. Follow the
prompts. After cleaning each tube,
using the supplied brushes soaked
in sanitizing solution, clean the
cabinet fittings and discharge ends.
26
It's easier to prep bottles
by first disconnecting the
cleaned tubes from the
cabinet fitting. Fasten
the other end of the tube
to the proper bottle and
immediately put bottle in
place and insert the other
end into the cabinet fitting.
This minimizes the chances
of spilling product.
Bottles installed in
cabinets.
29
Prime each
flavor one at
a time. Push
and hold
until product
goes into the
cup with a
consistent
stream.
12
25
27
14 8 10 12
13 7 9 11
2 4 6
1 3 5
28
14 8 10 12
13 7 9 11
2 4 6
1 3 5
30
If you
are done
cleaning
and ready to
prime, you'll
be asked to
load bottles
and connect
tubes.
Please note, the
end of the bottle
tube that goes into
the bottle may need
to be trimmed if it
is too long. The end
of the tube should
sit in lowest part of
the bottle.
Place a
container
underneath
the dispense
point to catch
product during
the priming
process.
Your unit is
now setup and
ready for use.
Manual #IxDM_Flavor+_101810 061224