Vector VECBC50 Instruction Manual page 3

LCD DISPLAY DETAIL
LCD DISPLAY DETAIL
A. Battery Reconditioning Icons
B. Battery Recondition Indicator
C. High Temperature Compensation Icon
D. Low Temperature Compensation Icon
E. Digital Display (varies by function)
F. Seconds/Voltage/Ampere Indicator
G. Fault Icon
H. Alternator Good/Fault Indicators
A A
B
O
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not approved by the party responsible for compliance could void user's authority to operate the equipment.
C D E
N L K
M
I. Alternator Icon
J. Pump Engine Icon
K. Overheat Alarm Icon
L. Alarm Icon
M. Clamp Icons
N. Reverse Polarity Icons
O. Battery Icon
F
J I
G
H
3