Advertisement
Advertisement
Related Manuals for Vector VEC088
Summary of Contents for Vector VEC088
- Page 2 GROUNDING PIN (A) METAL SCREW GROUNDING MEANS USE OF AN ADAPTER IS NOT ALLOWED IN CANADA. IF A GROUNDING TYPE RECEPTACLE IS NOT AVAILABLE, DO NOT USE THIS APPLIANCE UNTIL THE PROPER OUTLET IS INSTALLED BY A QUALIFIED ELECTRICIAN. VEC088...
-
Page 3: Preparing To Charge
When disconnecting charger, disconnect AC cord, remove clip from vehicle chassis, and then remove clip from battery terminal. h. See operating instructions for length of charge information. i. Do not charge the battery while the engine is operating. VEC088 VEC088... -
Page 4: Introduction And Features
INTRODUCTION AND FEATURES Thank you for selecting the Vector Model VEC088 2/6/12 Amp 12 volt Smart Battery Charger, with Check Alternator Voltage and Battery Recondition modes. With proper care and use, will give you years of dependable service. This model battery charger has a high charge rate of up to 35 amps, and low charge rate of up to 2 amps. - Page 7 NOTE: If there is any problem connecting the charger clamps to the battery terminals, contact the NOTE: Vector Technical Support Department toll-free at (866) 584-5504 for assistance. d) Plug battery charger power cord into grounded AC power outlet and refer to Appendix A at the end of this document for approximate charging times.
- Page 8 CHARGING TIMES CHARGING TIMES The VEC088 is a fully automatic battery charger. It automatically adjusts the charge rate as the battery becomes charged and stops charging when the battery is fully charged. if you require some estimate of the time takes to charge a battery refer to Appendix A for these details.
- Page 9 CARE AND MAINTENANCE CARE AND MAINTENANCE With only minimal maintenance, this Vector 2/6/12A Smart Battery Charger will deliver years of dependable service. Follow these simple steps to maintain the charger in optimum condition: ! After each use, clean the battery charger clamps be sure to remove any battery fluid that will cause corrosion of the copper clamps.
- Page 10 Try charging another battery, if the FAULT LED does not light, then one of the above problems exists. Charger will not charge and the fan will not operate if there is a fault. Call Vector Technical Support at (866) 584.5504...
- Page 11 In most cases, battery recharge times will vary depending on the age and condition of the battery. Smaller batteries should be charged at a lower rate (2 Amps) and add an extra hour to charge time. VEC088 VEC088 11 11...
- Page 12 30 days but less than five year from the purchase date, Vector Manufacturing will repair the unit or, at its option, replace it free of charge.