Page 1
Covaris Sponge Station & Automation Downholder Universal V2 Mounting Instructions Sponge Station & Automation Downholder Universal V2 Mounting Instructions Part Number: 010567 Rev A | October 2022...
Page 2
Registered names and trademarks used in this document, even when not specifically marked as such, are not to be considered unprotected by law. WCS and AFA are either registered trademarks or trademarks of Covaris, LLC in the United States and/or other countries. Information subject to change without notice.
Covaris Sponge Station Mounting Instructions • Sponge Station assembly, top to bottom: 1. Sponge Station Collar (part of PN 500772) 2. Sponge Flat (PN 520338) OR Sponge Dual Shelf (PN 520339) 3. Sponge Station Base (part of PN 500772) • When placing Sponge Flat, ensure that it fits within wall of Sponge Station Base.
Covaris Mounting Instructions by Liquid Handler Mounting Hardware Packs A. Hamilton STAR/STARlet/VANTAGE on Hamilton 7T Deck Segment (PN 500774) • Ask sales for recommended Hamilton deck segment type • 1x 7T deck segment (Hamilton PN 55574) Sponge Station & Automation Downholder Universal V2 Mounting Instructions...
Covaris B. Hamilton STAR/STARlet/VANTAGE on Hamilton Accessory (PN 500774) C. Mounting Hardware Pack - Dynamic Devices Lynx (PN 500776) Sponge Station & Automation Downholder Universal V2 Mounting Instructions Part Number: 010567 Rev A | October 2022...
Covaris D. Mounting Hardware Pack - Agilent Bravo (PN 500777) 1. Insert M4 to M6 thread adapter into Agilent Bravo deck segment, where the dead center of the accessory being installed will land. Ensure that the thread adapter is flush, or near flush but slightly recessed, with the deck segment.
Covaris Mounting the Automation Downholder Universal V2 to a Liquid Handler 1. Using a 3 mm allen key, separate the base plate from the main body by unscrewing at the red circled areas (as shown below). a. This allows access to the bolt holes (on the base plate) for mounting onto the liquid handler.
Covaris Attaching the Cable to the Automation Downholder Universal V2 There are two cables included with the Automation Downholder Universal V2 (PN 320332 and 320333) • Please plug cables in one of two configurations only: - Configuration 1: Both straight off the back - Configuration 2: Both angled upwards off the back Sponge Station &...
Covaris Notes Hamilton, STAR and VANTAGE Liquid Handling System are owned and/or registered by Hamilton Company in the U.S. and/or other countries. Dynamic Devices and Lynx are trademarks or registered trademarks of Dynamic Devices in the U.S. and/or other countries.
Need help?
Do you have a question about the 500772 and is the answer not in the manual?
Questions and answers