Definitions For Illuminated Lcd - CyberPower CPS3000PIE User Manual

CAUTION!
A battery can present a high risk of short circuit current and electrical shock.
Take the following precautions before replacing the battery:
1. Remove all watches, rings or other metal objects.
2. Only use tools with insulated handles.
3. Do not lay tools or metal parts on top of battery or any terminals.
4. Wear rubber gloves and boots.
5. Determine if the external battery is inadvertently grounded. If grounded, remove the
source of ground. CONTACT WITH GROUNDED BATTERY CAN RESULT IN
ELECTRICAL SHOCK!
The LCD Display indicates a variety of EPS operational
conditions. All descriptions apply when the EPS is
plugged into an AC outlet and turned on or when the
EPS is on battery.
1. INPUT VOLTAGE Meter: This meter measures the
AC voltage that the EPS is receiving from the utility wall
outlet. The EPS is designed, through the use of
automatic voltage regulation, to continuously supply
connected equipment with stable, 220 output voltages.
In the event of a complete power loss, severe brownout
or over-voltage the EPS will rely on its
to supply consistent 220 output voltage. The Input
Voltage Meter can be used as a diagnostic tool to identify
poor quality input power.
2. OUTPUT VOLTAGE Meter: This meter measures, the AC voltage that the EPS is
providing to the computer. It displays normal line mode, AVR mode, and battery backup
mode.
3. NORMAL MODE Icon: This icon will illuminate when the EPS is working under normal
conditions.
4. ON BAT (On Battery) Icon: During a severe brownout or blackout, this icon illuminates
and an alarm sounds (2 short beeps followed by a pause) to indicate the EPS is operating
from its external batteries.
continuously. When the BATTERY CAPACITY Meter shows one 20% capacity segment
remaining it indicates the EPS's external batteries are nearly out of power. You should save
files and shut down your equipment immediately.
5. AVR (Automatic Voltage Regulator) Icon: This icon will illuminate whenever your EPS
is automatically correcting high or low AC line voltage. This is a normal, automatic operation
of your EPS, and no action is required on your part.

DEFINITIONS FOR ILLUMINATED LCD

external battery
During a prolonged brownout or blackout, the alarm will sound
8
CPS3000PIE