Definitions For Illuminated Lcd - CyberPower CPS3500PIE User Manual

CPS3500&CPS5000 Series

DEFINITIONS FOR ILLUMINATED LCD

Definitions for illuminated LCD
The LCD Display indicates a variety of EPS operational conditions. All descriptions apply when the EPS
is plugged into an AC outlet and turned on or when the EPS is on battery.
1. INPUT VOLTAGE Meter: This meter measures the AC
voltage that the EPS is receiving from the utility wall outlet.
The EPS is designed, through the use of automatic voltage
regulation, to continuously supply connected equipment
with stable, 220 output voltages. In the event of a complete
power loss, severe brownout or over-voltage the EPS will
rely on its external battery to supply consistent 220 output
voltage. The Input Voltage Meter can be used as a
diagnostic tool to identify
poor quality input power.
2. OUTPUT VOLTAGE Meter: This meter measures, the
AC voltage that the EPS is providing to the equipments. It
displays normal line mode, AVR mode, and battery backup
mode.
3. ESTIMATE RUN TIME: This displays the run time estimate of the EPS. Once the run time becomes
shorter and the current battery capacity would decrease. (You can see the BATT. Bar chart keeps falling)
Note! This function of specified models cannot work.
4. NORMAL MODE Icon: This icon will illuminate when the EPS is working under normal conditions.
5. ON BAT (On Battery) Icon:
During a severe brownout or blackout, this icon illuminates and an alarm sounds (2 short beeps followed
by a pause) to indicate the EPS is operating from its external batteries. During a prolonged brownout or
blackout, the alarm will sound continuously. When the BATTERY CAPACITY Meter shows one 20%
capacity segment remaining it indicates the EPS's external batteries are nearly out of power. You should
save files and shut down your equipment immediately.
6. AVR (Automatic Voltage Regulator) Icon: This icon will illuminate whenever your EPS is
automatically correcting high or low AC line voltage. This is a normal, automatic operation of your EPS,
and no action is required on your part.
7. SILENT MODE Icon: This icon illuminates whenever the EPS is in silent mode. The buzzer will not
beep during the battery mode until the battery reaches low capacity.
8. OVER LOAD Icon: This icon will illuminate and an alarm will sound to indicate the battery supplied
outlets are overloaded. To clear the overload, unplug some of your equipment from the battery supplied
outlets until the icon is no longer illuminated and the alarm stops.
9. FAULT MODE Icon: This icon illuminates if there is a problem with the EPS. Please contact
10
Copyright © 2009 CyberPower Systems, Inc.