Troubleshooting - CyberPower CPS3000PIE User Manual

Battery Icon Flash
Fault Icon
Can Not Start Up
Problem
Full-time surge protection
outlets stop providing
power to equipment.
Circuit breaker button is
projecting from the side
of the unit
The EPS will not turn on.
Beep Once
1. Rapid Beep
2. Recurring Beep
3. Long Beep
None

TROUBLESHOOTING

Possible Cause
Circuit breaker has tripped
due to an overload.
The on/off switch is
designed to prevent damage
by rapidly turning it off and
on.
Mechanical problem.
Battery Missing- In Line
Mode Battery
Missing.
1. Low Battery
Output-Off
-- Insufficient battery
capacity.
2. Over Charge or AVR
Error-- In Line Mode,
battery is overcharged
or AVR is faulty.
3. Short Output-Off --
Output Short Circuit
Protection
1. Line Input/Output
Error Output-Off --
incorrect Input/Output
connection
2. Cold Start Battery
High Voltage
Output-Off -- the
battery voltage is too
high during cold start.
Turn the EPS off and unplug at least
one piece of equipment. Wait 10
seconds, reset the circuit breaker by
depressing the button, and then turn
the EPS on.
Turn the EPS off. Wait 10 seconds
and then turn the EPS on.
Contact Cyberpower Systems via
phone at +31 (0) 40 2348170 or visit
our website at
www.cyberpowersystems.com
12
CPS3000PIE
Turn the EPS off, check
battery wiring and
presence of battery
1. Recharge the
battery.
2. Inform service
agents.
3. Check the EPS
output to see if
there is a short
circuit.
1. Check Input/Output
connection.
2. Check the reason
for battery
over-voltage.
Solution