Installing Your Eps - CyberPower CPS3000PIE User Manual

UNPACKING
Inspect the EPS upon receipt. The box should contain the following:
EPS unit x1; Installation Guide x1; User manual x1; Warranty card x1.
AUTOMATIC VOLTAGE REGULATOR
Utility power is inconsistent. The EPS increases low voltage to computer safe 220 volts. The
EPS automatically provides battery backup (External battery connection required) if the
voltage drops below 140 volts or exceeds 300 volts.
HARDWARE INSTALLATION GUIDE
1. Your new EPS may be used immediately upon receipt. However, recharging the external
battery for at least 8 hours is recommended to ensure that the battery's maximum
charge capacity is achieved (Charging time varies with capacity and a 100Ah or great
battery is recommended). To recharge the external battery, simply leave the unit plugged
into an AC outlet. Your EPS is equipped with an auto-charge feature. When the EPS is
plugged into an AC outlet, the external battery will automatically recharge. The unit will
charge in both the ON and OFF positions.
2. DO NOT plug a laser printer, paper shredder, copier, space heater, vacuum or other
large electrical device into the EPS. The power demand of these devices may
overload and damage the unit. DO NOT use with medical or life support
equipment. DO NOT use with or near aquariums as condensation may cause the
unit to short.
3. After connecting the hard wires, plug the EPS into a 2 pole, 3 wire grounded receptacle
(wall outlet). Make sure the wall branch outlet is protected by a fuse or circuit breaker and
does not service equipment with large electrical demands (e.g. refrigerator, copier, etc...).
The warranty prohibits the use of extension cords, outlet strips, and surge strips.
4. Press the power switch to turn the unit on. The power on indicator light will illuminate and
the unit will beep once.
5. If an overload is detected, an audible alarm will sound and the unit will emit one long beep.
To correct this, turn the EPS off and unplug at least one piece of equipment from the
battery power supplied outlets. Wait 10 seconds. Make sure the circuit breaker is
depressed and then turn the EPS on.
6. To maintain optimal battery charge, leave the EPS plugged into an AC outlet at all times.
UPS will not function if the Bypass For Charge Only switch is enabled. Enabling the
switch provides the bypass for charge only.

INSTALLING YOUR EPS

4
CPS3000PIE